Trusted in Critical Situations.
 |
In addition to being a trusted bleach germicidal wipe that can be used in a variety of healthcare settings, these wipes also reduce damage to your equipment and other hard surfaces! |
 |
Contact Time is 4 Minutes
After application, surfaces only need to remain wet for 4 min to be fully disinfected.
|
 |
Effective Against 50 Microorganisms
Including Clostridioides difficile, Norovirus,
SARS-CoV-2 (Coronavirus) and 14 multi-drug resistant organisms
|
 |
Disinfection Formulation is
1:10 Sodium Hypochlorite
|
Reduce Damage To Your Equipment.
Sani-Cloth Bleach Germicidal Disposable Wipes are compatible with a wide range of surfaces. An independent, third party conducted a study to understand the compatibility of different bleach products on materials commonly used in healthcare equipment.
|
Reference: 1. Data on file. Intertek study report. PDI: Orangeburg, NY.
|
 |
You Can SEE The Difference:
|
|
No visible degradation on stainless steel, ABS plastic, brass alloy, and more.
*Study evaluated effect of liquid material on 26 solid, non-porous surfaces commonly in contact with disinfectant within the healthcare environment. Each surface material was wiped multiple times a day with the specific pre-moistened bleach product until 120 cycles were reached. At each cycle, the product was applied in typical wiping fashion, allowed to dry for about 45 minutes prior to the next cycle, followed by inspection for visual and/or physical deterioration of each surface material.
|
|
Healthcare Setting Uses:
|
Sani-ClothBleach Germicidal Disposable Wipes may be used on a wide variety of hard, nonporous surfaces:
|
bed railings
blood glucose meters (glucometers)
cabinets
carts
chairs
counters
dental unit instruments trays
exam tables
gurneys
isolettes
|
IV poles
stethoscopes
stretchers
tables
telephones
toilet seats
door handles
diagnostic equipment
patient monitoring equipment
patient support and delivery equipment
|
 |
You Can Even Use Them On Toys.
|
Sani-Cloth wipes are available in EPA-Registered formulations that are approved and labeled for use on hard, non-porous toys. The products clean and disinfect in a one-step process, unless visibly soiled. Once disinfected, toys should be rinsed with potable water (tap water) to remove any residue and allowed to air dry.
According to the Association for Professionals in Infection Control and Epidemiology (APIC), the recommended procedure for disinfecting toys is “Toys should be cleaned/disinfected between patients, especially those that are visibly soiled, mouthed, or used by patients in isolation. Toys should be washed thoroughly; disinfected with a non-toxic, low-level disinfectant and air dried completely.” Infection control experts recommend only washable toys for sharing. Stuffed animals and toys that cannot be cleaned and disinfected should not be shared.
Laisser un commentaire